12v Led Light Strip Installation

Extra adhesive tape 3m tape that you put on the surface before the strip to double the bond.

12v led light strip installation.

Now you could also want full on waterproof led strip lights ip67 if your lights are anywhere near your boats outer edge or even on the hull itself. A video showing the installation of an led light strip under the awning on our rv. Use a sharp knife to make a slit along the black lines between the light and the end of the led strip. Lights will have a pair of red and black wires coming from them.

Start by wiring all strips or strings of lights together. Installation tool list for 12v led light strips the tools you need for a complete installation are below. In these situations use one of the following. To get started with your diy 12v led light strip installation you need some tools.

Fitting led strip lighting on an rv awning is a perfect eco friendly solution to illuminating the exterior of your unit and to make the most of the camping experience using led lights rather than traditional lighting reduces your carbon footprint they re easier to install and versatile. Depending on where the lights are located on your boat this answer could change but at the very least we suggest weatherproof led strip lights which are graded ip65. Led strip mounting clips mounting brackets for strips. Wire the controller or lights directly to a power source of 12v and ground mount the light strips securely test and verify operation.

You ll need to plan to do the following. Place a connector in the other side of the clip so the strip can lay flush along the corners. Slide the end of the strip into one end of a connector clip and snap it shut. This means that all of the red wires will be connected together to run to the switch.

Because everything is already 12v you want to wire them in parallel. 1 cut strip light at the cut mark using the cutting interval instructions on pg. One or two reels of 12v led light strips you may need more depending on the project. 3 insert strip light into the connector so that the connector teeth will insert into the bottom of the strip light.

Peel the top layer off to expose the ends.